Comparison Of Different Discharging Methods Of Sigma Mixer | JCT Machinery

◪

The entire mixing cylinder is turned 45° to 110° through the hydraulic system, and the material is directly poured out.

◪

The cylinder is cleaned more thoroughly, the material is changed quickly, and it is easy to clean.

◪

The whole sigma mixer has high stability requirements and is suitable for large and medium-sized equipment (often equipped with more than 100L).

◪

After kneading, start the bottom screw to extrude the material evenly.

◪

Can be connected to the extrusion granulation system or heating mold.

◪

Continuous discharge, high efficiency, suitable for semi-automatic process.

◪

Cleaning requires disassembly and inspection of the screw, maintenance is slightly higher than the cylinder.

◪

Simple structure, easy maintenance.

◪

Controllable discharging, suitable for small batches of fine discharging.

◪

Suitable fot experimental or small capacity sigma mixer.

◪

Not suitable for extremely high viscosity or paste materials (may be blocked).